Anycubic Mega Filament Sensor Adapter

please check out my Upgrade, Settings (Cura) Guide for the Anycubic: [Guide](https://cubprin.com/en/anycubic-i3-mega-mega-s-upgrade-guide/)
schaut mal bei meiner Anleitung für jegliche Verbesserungen, Tipps und auch Einstellungen (Cura) vorbei: [Anleitung](https://cubprin.com/de/anycubic-i3-mega-mega-s-upgrade-anleitung/)

-----------------------------



This is a Filament Sensor Adapter, to mount the motor in an angle and also mount the sensor to the motor without any wiggling. This is for the Anycubic I3 Mega. It works best with a custom filament holder.

This is my filament spool holder:
https://www.thingiverse.com/thing:3409461


The original system with the magnet is just crap.

So i decided to design my own.


You just have to unscrew the lower screw, and put the adapter in. (look at the pictures). Use the same screw again.

Than, I used spare screws and nuts, which were included with my Anycubic to fix the motor and the sensor.