Thingiverse
Anycubic Mega S - Mega X Spool Support
di AlanLoi1981
95
Download
42
Likes
1
Makes
Simple and light spool support for Stock Anycubic Mega S/ Mega X spool support.
Adaptable width 35mm to 81mm.
Just clap on the stock support.
Pay attention, the design allow you to fit 81mm spool only if you put left and right in correct position, since they are designed to well fit each side of the stock support.
You need also:
x2 Bearings (608zz) 22x8x7mm.
Print with supports with 0.2/0.25 mm z offset from model.
If you printer is well calibrated in dimensions you don't need to scale.
Total cost for the print about 0.50 €, baerings excluded.
In CURA rotate the prints 90° on Y to use less possible supports.
Adaptable width 35mm to 81mm.
Just clap on the stock support.
Pay attention, the design allow you to fit 81mm spool only if you put left and right in correct position, since they are designed to well fit each side of the stock support.
You need also:
x2 Bearings (608zz) 22x8x7mm.
Print with supports with 0.2/0.25 mm z offset from model.
If you printer is well calibrated in dimensions you don't need to scale.
Total cost for the print about 0.50 €, baerings excluded.
In CURA rotate the prints 90° on Y to use less possible supports.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
