Thingiverse
Anycubic Mega S USB Support
von Casperette
12
Downloads
6
Likes
0
Makes
A small external sleeve to protect the USB-B port on the internal Arduino board in the Anycubic Mega S.
Modified the USB support from afterwords to fit the anycubic mega port and my cable. Inside is 11mmx12mm but you can scale as needed for your cable. I used 3M double sided tape and its on there for good.
Modified the USB support from afterwords to fit the anycubic mega port and my cable. Inside is 11mmx12mm but you can scale as needed for your cable. I used 3M double sided tape and its on there for good.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
