Anycubic Mega X Hemera

### Important

I must warn you, **I have not tested this** model as I do not have this extruder. **I drew it out just for fun**. Based on the layout, this should work without any problems with Hemera and Matrix extruders, but, alas, I cannot guarantee that there will be no problems.

##### Common

The idea was to make the model as simple as possible and to print without support.

##### Assembly

How it works in my head:

After you print the part, you need to clean the holes for mounting the motor with a drill under m3, since they have a membrane.

In order to fix the extruder, you need m3x6 (2) screws, as well as one m5x35 screw for fixing the carriage. You will also need m3 (3) hex nuts.

First you need to install the hex nuts in the corresponding grooves. Then you need to screw on the motor and after that you can fix the part on the base plate with screws m3 and m5.

Do not forget to attach the stopper, is now the X-axis limit switch will not work without it.

Now