Anycubic Predator Internal Filament Sensor Guide

This is a pretty simple modification to the Predator Internal Filament Sensor by NexxCat. I simply rounded the edges of the filament entrance hole and the outer edges of the cap.

Instructions from NexxCat's design are the same for this, with the exception that I removed the length of bowden tube entirely in step 10 as it wasn't really needed.:

Installation instructions are as follows:

1. Print PredatorFilamentGuide.stl, PLA is fine. make sure to orient the print so that the widest round area is flat on the bottom
2. Disconnect your printer from mains electricity.
3. Remove the acrylic top cover by removing the 6 screws around its edges
4. Remove the short length of bowden tube but leave the fitting in place.
5. Remove the existing filament sensor, taking care not to damage the connector.
6. Flip the sensor upside down and align it so that the exit hole of the tube is lined up with the entrance hole to the bottom fitting hole. you may have to bend the mount slightly to