Anycubic Predator mosquito clone

Warning: this modification requires the use of the saw and file.
Sorry for my English ....

2 x 3x10 screw
2 x 3x16 screws
2 M3 nuts
2 M3 washers
2 screws 2.5x8
4 screws 2x16 (fans and duct)
It is printed in petg, although I think in pla, it would also work.

No modification is required in the predator effector.
Cut with a saw a little of the sheet of the original support of the fans of the predator, so that between the piece of the mosquito with the heater and the thermistor, mount it in reverse of how it went under the effector. Revise with a drill the threaded hole of the sheet that held the fan of the original hottend, as it would bother when putting the new screws.