Anycubic Predator Reroute Project.

Work in Progress.

The printed parts are now ready, well just about anyway.
I will divide the parts into smaller groups..(done).

The purpose is to route the wires more neatly and probably
also the filament.

For 13mm wire harness (outer diameter).

Assemble: M4 Nuts 9 pcs. M4 Washers 10 pcs. Screws, M4x12 5 pcs, M4x16 4 pcs,
1 x M5x 38 + M5 nut & washer.
+ a couple of suitable springs.

To frame: M5x12 4 pcs and M5 T Slot Nuts pcs.

-Parts 1-3, no parts for rerouting the filament, only the wires (using 13mm OD harness).
-Parts 4, when also rerouting the filament.
-Parts 5, when using protecting corrugated tube for the filament (OD 9mm).
(in that is the case, skip parts 4).


If someone is about to do the same, then maybe those parts would be helpful.