Anycubic Predator TFT70 Adapter

Hello again folks....

Here is the TFT70 version of my slotted panel adapter.

Please try to use 0.4 nozzle as some details start to go funky!

May require sanding to make the slot work, but before anyone moans, i printed at 0.2layer and didnt need any post processing.. ( apart from, two little pieces on the small right section will print strangely, i forgot to snip them of in the design.. just be careful and use some flush cutters, you will see where i mean)

This design will not work correct if printed in one whole piece so there isn't one in this pack, please dont ask me for one. It must be printed in 2 or 3 pieces.

Once all parts are printed,
1. You will need to mount the left side to the printer.
2. The TFT70 will need to be mounted to the middle section.
3. Add the small right section to the middle section and then slot that whole piece onto the already mounted left section and finish mounting with screws in the right side.
4. Dont forget the beer!