Thingiverse
Anycubic Spool Holder
von flmk974
9
Downloads
6
Likes
0
Makes
I designed this big screw and nut to perfectly center the filament spool on the Anycubic Spool Holder.
This screw fits perfectly to the width of the Anycubic Spool Holder, so, the filament spool will not move from right to left.
Enjoy.
Edit (15/01/2019): Added the Anycubic Spool Holder v2. I added more clearance, and the thread is bigger, and so, faster to screw.
This screw fits perfectly to the width of the Anycubic Spool Holder, so, the filament spool will not move from right to left.
Enjoy.
Edit (15/01/2019): Added the Anycubic Spool Holder v2. I added more clearance, and the thread is bigger, and so, faster to screw.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
