Anycubic Spool organizer

My offering is a bin storage system for Anycubic plastic filament spools. * This was designed for Anycubic plastic spools only* The inside width of the assembled spool is 60mm and my design allows you to create any combination of sizes per "slot". Whenever you place multiple bins in a slot you will need to add a piece of 2.5mm rod 40mm long so the middle bins will hinge and not fall out. I recommend tapping the bin holes with a 3mm tap although not necessary. Also, I would recommend using only one double bin per roll as it interferes with the screw holes for the lid (each double bin prevents use of one lid hole) For attachment I used M3 x 8mm on top and M3 x 12 on the bottom.

!!You must remove the alignment notch inside the roll. Also use the holes on top and bottom closest to the center. They are approximately 9mm from the edge!!

I've also added a fancy spool connector piece so they can be stacked securely and capped off with a Plain lid. Unfortunately the connector and Lid with C