Anycubic Vyper - Modified cablechain base unit

hengzefong have done nice work to this, however the "wide" cablechain up to the extruder collided with the heated bed, when going over 200mm in height.

Not enough cable to give more slack on my model (Vyper from May 2021 model), so needed to "move" the mount of the wide cablechain a bit more to the side.

No part file, so I measured it up and designed one myself.
And anyway when at it, fiddled with some text so it looked a bit different.

It is designed with a small bevel, that must face downwards (logic way of printing it anyway), this to compensate for potential "elephants foot" when you are to slide it into the V-slot profile afterwards.

I also designed it slightly thicker, as while I was carving with a knife to get the original to fit, I of course broke one of the connectors (too weak). Still plenty of space for both cables.