Anycubic Vyper Top Spool Conversion Kit

==============================
Anycubic Vyper Top Spool Conversion Kit
==============================

The following set was created by Thingiverse User "TheLastItch" (Greg Scratchley at https://www.rysk.ca) as a collection to enable users to print all of the necessary components to modify a standard AnyCubic Vyper to a top-feed gantry spool device (reducing footprint substantially). See attributions below.

The top spool holder is from taka0909 on Thingiverse: https://www.thingiverse.com/thing:5193142
The 45 degree bracket relocate was remixed from JBDoge on Thingiverse: https://www.thingiverse.com/thing:5198488
The Gantry guide was remixed from padrino73 on Thingiverse: https://www.thingiverse.com/thing:5407451

Gantry arm and Run-Out relocate have holes which should allow you to thread in (with just a wrench) M6 and M10 fittings for a piece of PTFE to guide filament.

Run-out bracket uses factory M3 screws to attach the bracket to the printer. Run out sensor requires a M3x15 and nu