Slicer Discord
Aoocci Remote Bracket for C6 – 3D printable model from MakerWorld MakerWorld
Vehicles

Aoocci Remote Bracket for C6

by Kita · Vehicles
4 Downloads
1 Likes
2 Makes
Go to Model
Bracket for the Aoocci C6 remote. Since the remote bracket was made from the same junk plastic as the camera mounts, I recreated it myself. It is setup for a 28mm bar, but could be adjusted as needed, or just put some spacers between the bar and bracket. I created this to use the included Aoocci hardware that comes with the stock bracket. I printed this in PETG at 100% infill. I recommend that you do not use PLA as it will degrade and likely fail from heat and the sun.
Category
Vehicles
Source
MakerWorld
Published
Updated
What you need to print this: Intermediate Low confidence
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
PLA, PETG
Min. bed size
50 mm (Small)
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection