AOpen desktop PC case foot

The original plastic feet from my AOpen SFF Micro ATX desktop PC case have started to become brittle from sun yellowing and when one snapped, I made a close replacement in F360

I printed them at low quality/detail and the layer lines really show at the top of the protruding foot part. it's up to you if this bothers you enough to print at a higher quality but for me that was fine.

you want to maximize strength in the Z direction so use a straight vertical infil like grid, triangle or tri-hexagon. There are also internal vertical holes so that there are vertical wall shafts that go all the way through for added vertical strength.