Thingiverse
Aperture Sciences Logo Coaster
von bocosalad
3
Downloads
0
Likes
0
Makes
Just a coaster with the Aperture Science Logo. I printed it on a resin printer but I am sure FDM would do fine.
Hand painted after the fact, but multi-colored layers could be possible as well if you remove the slight outer brim on the top layers.
Hand painted after the fact, but multi-colored layers could be possible as well if you remove the slight outer brim on the top layers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!