Slicer Discord
Apex Nano Side Marker Plug – 3D printable model from Thingiverse Thingiverse

Apex Nano Side Marker Plug

by pb300
0 Downloads
0 Likes
0 Makes
Go to Model
This is a filler plug for the side marker lights on a Coachmen Apex Nano trailer. The factory drills a 1.5" hole to run a couple wires through. This plug fills most of the hole to make it easier to seal with silicone. I sized it just over 1.5" so it should fit snugly.

Feed the wire into the slot. Push the plug just below the wall surface. Add some silicone in the slot and all over the face of the plug. Smush the light into the silicone and screw it in place.
Source
Thingiverse
What you need to print this: Intermediate Low confidence
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
PLA
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection