Apollo Ghost Kickstand Extension

Another creation to extend the stock kickstand for Apollo Ghost, which is known to have a very steep leaning angle. This shall raise the original kickstand 3cm from ground.

Print both side and assemble with 4 screws. All holes are 4mm. I used M3 screws and nuts to hold both sides. Brass inserts is preferred. I made a tight cut out for the metal feet section, which may need some heat to fit. I print all parts in PLA+. PETG or TPU may be better for the foot. Foot holes are in M3 and shall fit the flat head M3 x 15mm. Foot is 8mm tall can extend to raise further.

Feel free to remix