Apple II Plus Power Light Base

This is the bottom part for the power light cover for an Apple II Plus computer. This is the piece that sockets into the keyboard plate. The cover fits over top.

It is a redesign of the original Apple part. This one provides better fit and strength. You may have to sand the long edges down a little bit for a proper fit as it is quite snug, and there is variation between keyboard plates. Apple used a few different keyboard suppliers.

Slicer: Simplify 3D
Nozzle size: 0.4mm
Extrusion width: 0.45mm
Layer height: 0.25mm
Temp: 210C (misc PLA material)
Cooling 25% fan after 1st later
Advanced (Simplify specific setting): Inner thin wall type: allow single extrusion fill
Recommended printing colour : White