Thingiverse
Apple Pencil Tip Protector
von mitchellfrasure
7
Downloads
7
Likes
0
Makes
This works when printed in vase mode with a .4mm nozzle. I printed mine in amazon basics orange PETG.
The lip that holds the tip on the pencil will require some light sanding/filing in order to slip all the way on and clip around the base of the apple pencil tip.
The very top of the model will also require some sanding/filing in order to remove the nub that is left at the end of the print.
once the model is cleaned up a little bit, it should fit snugly around the apple pencil tip while still allowing your device to register the pencil input.
The lip that holds the tip on the pencil will require some light sanding/filing in order to slip all the way on and clip around the base of the apple pencil tip.
The very top of the model will also require some sanding/filing in order to remove the nub that is left at the end of the print.
once the model is cleaned up a little bit, it should fit snugly around the apple pencil tip while still allowing your device to register the pencil input.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
