Thingiverse
Apple TV Mount
door Lippy
8
Downloads
2
Likes
0
Makes
I made this mount to keep an AppleTV on the back of a cheap swivel wall-mount where there was no easy way to mount the AppleTV and still be able to get line of site with the remote.
The 3 parts are printed separately, then the Cap is slid up from the bottom of the base and I glued it in place. The 'Cap Tip' just provides a ledge for the cables to sit on, to prevent them from weighing down the back of the ATV and causing it to tip up.
The 3 parts of this are all in the attached scad file, two of the 3 are commented out.
The 3 parts are printed separately, then the Cap is slid up from the bottom of the base and I glued it in place. The 'Cap Tip' just provides a ledge for the cables to sit on, to prevent them from weighing down the back of the ATV and causing it to tip up.
The 3 parts of this are all in the attached scad file, two of the 3 are commented out.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
