Thingiverse
Apple TV Remote Em-BIG-ifier
von DCRobotics
15
Downloads
3
Likes
0
Makes
The Apple TV Remote is notorious for falling between couch cushions. This device makes the remote 225% bigger so that hopefully it doesn't do this anymore. I used Fusion 360 to model this thing based on a CAD file of the actual remote, so the curves on the top and bottom are the same as the original remote.
The tolerance between the remote and the inside of this Em-BIG-ifier is 0.2mm. If you find that this is too much and your remote slides out of this front of this thing, simply add a piece of duct tape or two under the remote (attached to the thing, not the remote).
No supports needed, simply print standing up.
The tolerance between the remote and the inside of this Em-BIG-ifier is 0.2mm. If you find that this is too much and your remote slides out of this front of this thing, simply add a piece of duct tape or two under the remote (attached to the thing, not the remote).
No supports needed, simply print standing up.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
