Apple Watch Charging Dock

Important note: you may need to use some force to remove the charger from the dock. It is a little difficult ʘ‿ʘLow-poly charging stand for the Apple Watch. Tested with 44mm and 40mm models. Not tested with Apple Watch Ultra. The stand has been designed to print very easily without any supports, and takes roughly 2 to 2:30 hours to print. Higher infill percentages are recommended to add a little extra weight to the stand. Please print the test piece to see if your watch charger will fit snug, and adjust your slicer's XY size compensation value if the charger is too loose or does not fit. The accent piece is optional if you would like to add a two-tone look to the stand, and is attached with 3x countersunk M3x10mm screws. Alternatively, you can superglue the piece to the stand if you wish. Boost MeLike my models? Support me by boosting my models :)