Thingiverse
Apple Watch Charging Stand
por Jeff5263
4
Descargas
4
Likes
0
Makes
This is two projects for charging an Apple Watch. One is a stand for a table or countertop and one can be screwed or magnetized to a wall or other vertical surface.
As the photo illustrates, it's best to use partial support on the end of the column piece that has a notch on the top.
Materials needed are 4-m2 self-tapping screws that are anywhere from 4-10mm long. And of course you'll need the charging 'puck' that came with your watch. If you want to use the small charging stand with magnets it has indentations to insert two 12mm by 2mm magnets. They're available on eBay. They're glued in with epoxy.
The only print support needed is the end of the column as previously mentioned.
As the photo illustrates, it's best to use partial support on the end of the column piece that has a notch on the top.
Materials needed are 4-m2 self-tapping screws that are anywhere from 4-10mm long. And of course you'll need the charging 'puck' that came with your watch. If you want to use the small charging stand with magnets it has indentations to insert two 12mm by 2mm magnets. They're available on eBay. They're glued in with epoxy.
The only print support needed is the end of the column as previously mentioned.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
