Apple Watch Holder

I made this because my Apple Watch charger was always sliding off my nightstand. I just wanted something simple that stays in one spot and looks clean.About the stand:How it works: The charger just presses into the hole. No glue or tape needed.Hidden wires: There is a spot in the back to run the cable so it doesn't look messy.Easy to see: It holds the watch at a good spot so you can see the time if you use it as a clock at night.How to print it: I used PLA and it worked great. To get the best results, make sure you print it on its side. You shouldn't need any supports if you lay it down that way. I'd suggest using 3 or 4 walls so it feels solid and doesn't move around when you put your watch on it.If you print one, let me know how it goes!