Thingiverse
Gadgets
Go to Model
AppleWatch charging stand
172
Downloads
435
Likes
3
Makes
Charging stand for AppleWatch. Supports Apple branded charging cables with either USB-C or USB-A connectors.
Installation:
1) Install AppleWatch magsafe charger to the Body. Note: the charging surface is on opposite side from where the cable is routed (i.e. the cable is routed on the backside of the stand)
2) Insert USB connector through hole in Base
3) Connect Body to the Base and insert cable to slot on the Base. Note: the Body attaches to the left side of the Base and the cable routing is on the back and underside of the stand.
4) Install Cover, it keeps the 2 sides of the Body that insert into the Base apart and locked into place. Note; the cable should be following the curvature of the Cover.
[OPTIONAL] After verifying the printed pieces fit together, some super glue to could be used if you don't plan to disassemble the stand.
Installation:
1) Install AppleWatch magsafe charger to the Body. Note: the charging surface is on opposite side from where the cable is routed (i.e. the cable is routed on the backside of the stand)
2) Insert USB connector through hole in Base
3) Connect Body to the Base and insert cable to slot on the Base. Note: the Body attaches to the left side of the Base and the cable routing is on the back and underside of the stand.
4) Install Cover, it keeps the 2 sides of the Body that insert into the Base apart and locked into place. Note; the cable should be following the curvature of the Cover.
[OPTIONAL] After verifying the printed pieces fit together, some super glue to could be used if you don't plan to disassemble the stand.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
