AppleWatchCradle - SMALL

Please print 90 degrees rotated to right side (not on the side where the cable leaves the stand).

I recommend setting overhang support structures to above an angle of 60 degrees. The structures will only be necessary in the main opening which takes up the loading device.

This stand was designed to fit perfectly to our bed. You might have to adjust it to the dimensions of yours... The fotos provided show a slightly older model with an (unnecessary) second supporting layer in the back.

There is a second version for the larger size model. You'll find it under the same name but without the "-SMALL" in the end.

Made with Tinkercad. Edit it onlinehttps://www.tinkercad.com/things/bmCBoQ8mXoi