AprilTag VR Mount

For use with AprilTag VR trackers. See below for full BOM for a single AprilTag mount. Two can be used on the legs/ankles, and half of one can be used for hip tracking.

Note, BaseMountFold may be too large depending on your print bed. If this is the case, BaseMountNonFold can be used.

BaseMountFold X2 - OR- BaseMountNonFold
BaseMountLink X4
BandRetentionPin X2
BandRetentionCap X2
Hinge X4
HingeLimitPin X1
HingeLimitCap X1
Lock X1
LockingPin X1
Pins X1

Non Printed Parts
M3 x 16mm X8
M3 nuts X6
Rubber Bands X2

Depending on printer resolution and other settings, some holes may need to be drilled out, but they should be a good fit for the most part.

Depending on the strength of the rubber bands, you may not need the locking pin, but I found that it helps keep it more secure. While it hasn't happened to me, be careful not to get pinched by the mechanism when it closes.

I normally wear them with either just socks or sweats on, or both. If you wear them against