Thingiverse
APS CAM M41A DUMMY
von SplatBones
1
Downloads
1
Likes
0
Makes
M41A prop for dry fire from APS CAM airsoft. DRY FIRE ONLY.
Print standing vertical, no support. 100% infill.
Start off with silver filament, change to red at layer 145, then white at 156, then back to red at 166.
Laminating with epoxy resin may reinforce the shell enough for firing, but this is untested as of yet.
Print standing vertical, no support. 100% infill.
Start off with silver filament, change to red at layer 145, then white at 156, then back to red at 166.
Laminating with epoxy resin may reinforce the shell enough for firing, but this is untested as of yet.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!