Thingiverse
aPump mounting bracket
von SuperOldboy
1
Downloads
0
Likes
0
Makes
This is a mounting bracket for the aPump.
You can print it "standing up".
You have to take off the suction cup at the back for it to fit.
I put some tape over the hole where the suction cup was in.
also if you want to lower vibrations, put some tape on the back of the bracket so it doesn´t touch your aquarium cabinet.
You can print it "standing up".
You have to take off the suction cup at the back for it to fit.
I put some tape over the hole where the suction cup was in.
also if you want to lower vibrations, put some tape on the back of the bracket so it doesn´t touch your aquarium cabinet.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
