MakerWorld
Electronics
Model downloaden
Aqara Temperature sensor housing
2
Downloads
0
Likes
1
Makes
Two part outdoor housing for the Aqara temperature and humidity sensor. I printed the inner part in PETG (it's quite thin and it's got the attachment points on it) and the outer part in PLA (white). The sensor slides into the inner part which in turn slides into the outer part. The two “ears” on the inner part pokes through the outer part to create an attachment point for the contraption. Mine is mounted under a coffee table outside, but i can't guarantee that it's water &/ weatherproof so use at your own risk :o)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!