Thingiverse
AR Upper Vice Block
door holydeltawings
377
Downloads
144
Likes
1
Makes
This is an AR15 upper vice block for assembly.
Do not print it vertical as the layer adhesion will fail. I have not attempted to print it on its side but if you print it sideways it may hold up.
After assembly, ream out the pin holes with a 1/4 drill bit. a simple 1/4 metal rod will fit though the takedown pin holes allowing for a secure fix.
Do not print it vertical as the layer adhesion will fail. I have not attempted to print it on its side but if you print it sideways it may hold up.
After assembly, ream out the pin holes with a 1/4 drill bit. a simple 1/4 metal rod will fit though the takedown pin holes allowing for a secure fix.
holydeltawings publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
