Thingiverse
Arcade Button Wrench
von Charles148
14
Downloads
10
Likes
0
Makes
Wrenches for arcade buttons.
One for 32mm nuts that fit onto standard 1 1/8 inch (28mm) Happ-style buttons.
One for 28mm nuts that fit onto 24mm buttons.
Both are deep enough to accommodate the deepest buttons I have (tried with a variety) all the way (with or without a panel) and thin enough to fit buttons that are fairly closely spaced.
In PLA with 10% infill they are strong enough to tighten or loosen any button I've tried.
With the assortment of buttons I have some fit tight, some have a little play, havent found one it doesn't work on.
One for 32mm nuts that fit onto standard 1 1/8 inch (28mm) Happ-style buttons.
One for 28mm nuts that fit onto 24mm buttons.
Both are deep enough to accommodate the deepest buttons I have (tried with a variety) all the way (with or without a panel) and thin enough to fit buttons that are fairly closely spaced.
In PLA with 10% infill they are strong enough to tighten or loosen any button I've tried.
With the assortment of buttons I have some fit tight, some have a little play, havent found one it doesn't work on.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!