Arcade Joystick Box

An arcade stick controller box, for use with an arcade stick and buttons and a USB Controller board bought from amazon.

https://www.amazon.co.uk/EG-Joystick-Buttons-Retropie-Raspberry/dp/B075J882S8

Currently being use with MiSTer.

Sketchup Design file is included to adjust for your arcade needs.

There are two versions of the Top controller part, one is slightly Taller for more of an angle.
It should not require Supports, but your printer may vary.

I also printed the Mid section with a brim, rather than a skirt for the other parts.

You will need some M3 (16mm) screws to screw the base and the top together and some coach bolts for the stick and M2 (5mm) screws for the USB Board.

I also left some holes on the base if you want to use some suction cup feet or you can get some rubber feet to screw through the base to top holes also. This will require longer screws depending on your rubber feet size.