Thingiverse
Arcade Joystick - pi_arcade
by darevix
845
Downloads
627
Likes
4
Makes
This is my version of an arcade joystick with a built-in raspberry pi 3. The hard disk holder is optional and can be attached to the base.
My printing platform is relatively small 20x21cm and I have had to split the main part, If your platform is bigger you can print the whole piece.
If the green lines do not enter try to fit them gently with a hammer.
Electronics:
- Raspberry PI B/2/3 (https://goo.gl/dpNFVS)
- Arcade Sanwa Joystick DIY Kit (15€ Aliexpress) (https://goo.gl/FqakxT)
- USB hub (optional, I bought it at a local store)
- WD PiDrive (optional, https://goo.gl/Zd2Mso)
My printing platform is relatively small 20x21cm and I have had to split the main part, If your platform is bigger you can print the whole piece.
If the green lines do not enter try to fit them gently with a hammer.
Electronics:
- Raspberry PI B/2/3 (https://goo.gl/dpNFVS)
- Arcade Sanwa Joystick DIY Kit (15€ Aliexpress) (https://goo.gl/FqakxT)
- USB hub (optional, I bought it at a local store)
- WD PiDrive (optional, https://goo.gl/Zd2Mso)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
