Arcade Spinner using a Mouse

Parts

1 x Mouse (I used a Logitech M90)
1 x Ball bearing 8mm x 12mm x 3.5mm Ball Bearing
2 x Sanwa OBSF-30 buttons
1 x PG7 cable gland
6 x Screws for box - Self tapping 15mm long with a diameter of 3.5mm
2 x Small screws to attach mouse
Other: blue masking tape, small washer and wire


The bottom part of the box contains stands to support a Logitech M90 mouse. You will need to adapt these or improvise to support a different mouse.

The ball bearing should snap into place into the lid of the box. Push the spinner top into the ball bearing until there is about 3mm of clearance between the top of the lid and the bottom of the spinner handle. Apply a tiny bit of super glue to the bottom part of the shaft where it meets the inner part of the ball bearing.

To position the bottom part of the spinner, I glued a tiny washer onto the mouse and only slightly positioned the bottom spinner piece into the shaft of the top spinner piece and let it slide into the correct depth as I p