Thingiverse

Arcane Summoning Circle Portal

von valentino_42

2k Downloads

1.3k Likes

0 Makes

Zum Modell

This is an arcane summoning portal for your NPC's demon summoning needs.

Everything was printed at .2mm layer height. The top and bottom pieces can be any filament your heart desires, but for the lighting effect, the "portal" portion will need to be printed in a translucent plastic (or you can forgo this piece altogether and use some other piece of colored plastic you have on hand - a soda bottle, a lighting gel, the side of an old rubbermaid tub, etc).

The bottom and portal pieces print straight on the bed, no problems, with no supports needed. The top ended up needing to be printed face up with supports (I also used a raft, but I think this was overkill). I think it's possible to print this face down with no supports, but my bed adhesion just wan't up to the challenge.

I glued the "portal" piece to the top section, but left the top and bottom separate so I can turn off and on the lights inside.

For lighting, I used this set of lights from Amazon (Govee Fairy Lights): htt

arcane circle demon dungeons and dragons lich necromancer portal RPG Summoning Terrain wizard arcane circle demon dungeons and dragons lich necromancer portal RPG Summoning Terrain wizard arcane circle demon dungeons and dragons lich necromancer portal RPG Summoning Terrain wizard

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Warum?

0.20mm Schichten

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker