Arch & Ball

This is an old model that I never got around to publishing.

Adding some sand, pebbles or marbles will add enough weight to support heavier flowers if needed or desired.


I used Prusament PLA in Marble Grey. .2mm SPEED, modified to 2 outer shells, no top layers, 5 bottom layers, no infill. I also unchecked Insure Vertical Thickness under Quality on the Layers and Perimeters tab. Using these settings, the 101.6mm version will take about 2hr 15min, and the 152.4mm version will take about 3hr 29min. The gcode files I used are included here. gcode will work on Prusa mk3 I3/S/+.