Archery Arrow Feather Corrector (updated)

This item is made for correcting the feathers of 8mm Arrows with soft plastic feathers.
Also very useful when you need to replace damaged ones - easy to get the new one in position!
Note: ABS or other heat resistant material needed, no PLA.

How to:
- Print "part 1" 2pcs and "part 2" 3pcs
- (Gluing them all together could be useful but is not necessary. If you want to, 2K glue might be good)
- Connect all parts and put it over the feathers of the arrow as seen in the pictures
- Get some hot water (80°C / 176°F)
- Put the feathers with the corrector attached into the water for 5-10sec
- Get it outside and move the corrector up and down a little bit (pls don't boil your hands)
- Either wait for cooling down or get some cold water

Update notes:
12-12-2017: Part 2 has got a better fitting to part one (little tolerance gap added).