Thingiverse
Archery - arrowhead & arrow extender
von DanZbo
74
Downloads
60
Likes
0
Makes
### Info
Both designed for 8mm arrows.
I print arrowhead with 100% infill PLA and it works fine. For more durability, you can use etc. PETG, ABS.
### Recommended usage:
+ Use the extender as close to the tip as possible for maximum efficiency (picture 3, method 3). If you use method 2 from pic. 3, arrow will break after small shake. (I tested shoot with it, and it survived one shot. After that It broke in my hand after few seconds.)
+ You can use tape for smooth transition between extender and arrow body or wrap the entire extender.
+ **IMPORTANT**: I use super glue to connect two arrowheads, although you can wrap the entire extender in super glue for more durability - **recommended**
If you do not follow the recommended usage, the extender is more likely to break as follow in picture 4.
Both designed for 8mm arrows.
I print arrowhead with 100% infill PLA and it works fine. For more durability, you can use etc. PETG, ABS.
### Recommended usage:
+ Use the extender as close to the tip as possible for maximum efficiency (picture 3, method 3). If you use method 2 from pic. 3, arrow will break after small shake. (I tested shoot with it, and it survived one shot. After that It broke in my hand after few seconds.)
+ You can use tape for smooth transition between extender and arrow body or wrap the entire extender.
+ **IMPORTANT**: I use super glue to connect two arrowheads, although you can wrap the entire extender in super glue for more durability - **recommended**
If you do not follow the recommended usage, the extender is more likely to break as follow in picture 4.
DanZbo veröffentlicht auch auf
99 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
