Archery Quiver (Large)

I wanted a holder for storage of my arrows and that could also be used as a normal wearable quiver.This design is printed in three parts, a top and bottom half and a joiner. The joiner is simply glued into the centre as the the two halves are pressed together.The overall length is 490mm and it is 100mm wide and 50mm deep. It can hold approximately 40 arrows (5mm shaft).I made provision for a strap to be fitted if it is used as a wearable quiver.It was printed on a Bambu Labs X1 Carbon using ABS but it can be printed in any filament type that you prefer.Enjoy!