Thingiverse
Arctic Cat 120 ski loop
von mattherberg
1
Downloads
0
Likes
0
Makes
Artic Cat ski loop made as a replacement. I used PLA + with 20 walls and 30% infill.
It barely fit on my ender 5 plus bed. 220x220mm.
I didn't use any supports, but you may need to clean up the horizontal hole.
It barely fit on my ender 5 plus bed. 220x220mm.
I didn't use any supports, but you may need to clean up the horizontal hole.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!