Thingiverse
Ardent Reapers Deck Case
von tuegc
0
Downloads
0
Likes
0
Makes
The case is made for 66mmx91mm standard sleeves.
The top can be a tight fit depending on the printer, so sand the outside corners of the bottom and the inside corners of the top. After that slowly put on the lid a bit of the time and taking it off so that it wont get to stuck. the top will have a nice firm hold on the bottom and wont fall off by it self.
Printed at 0.3 on a Prusa mk3s+
The top can be a tight fit depending on the printer, so sand the outside corners of the bottom and the inside corners of the top. After that slowly put on the lid a bit of the time and taking it off so that it wont get to stuck. the top will have a nice firm hold on the bottom and wont fall off by it self.
Printed at 0.3 on a Prusa mk3s+
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!