Arducam for Raspberry Pi Camera Enclosure

Some time ago, I bought this UC-261, Rev.D camera from Amazon. After searching around on Thingiverse, I could not find a model that fit this model of camera. The Things I did find, were close but too small or the alignments were off. So I "engineered" my own enclosure and posted it here.

Keep in mind, this isn't intended to be the finished project. I just did the hard part. Obviously, you'll want to incorporate this piece into a larger project, perhaps one that includes an arm or a flat piece for the ribbon cable. So feel free to remix this as you see fit. And I'm sure there are others who figured this one out, I just couldn't find them.

You'll notice a groove on the back side, this was done so that the screws on the back of the camera can recess into the frame instead of rocking back and forth.

Printed on a Bambu P1P, with PLA at 20% infill. No supports needed, but I'd suggest a brim.