Thingiverse
Arducam IMX477 casing
von DaviiD1984
4
Downloads
0
Likes
0
Makes
Industrial alike casing for:
- Arducam IMX477 camera (https://www.arducam.com/product/b0242-arducam-imx477-hq-camera/)
- Arducam CSI to HDMI interface (https://www.arducam.com/product/arducam-csi-hdmi-cable-extension-module-15pin-60mm-fpc-cable-raspberry-pi-camera-specific-pack-2-1-set/)
Screws/nuts required:
- 4x M3 nut
- 4x M3x40mm screw
- 8x 2x10 spax
A plug on a side is printed from TPU and intended for getting cables for multi sensor sync out of the enclosure.
A M3-.50 nut is required.
- Arducam IMX477 camera (https://www.arducam.com/product/b0242-arducam-imx477-hq-camera/)
- Arducam CSI to HDMI interface (https://www.arducam.com/product/arducam-csi-hdmi-cable-extension-module-15pin-60mm-fpc-cable-raspberry-pi-camera-specific-pack-2-1-set/)
Screws/nuts required:
- 4x M3 nut
- 4x M3x40mm screw
- 8x 2x10 spax
A plug on a side is printed from TPU and intended for getting cables for multi sensor sync out of the enclosure.
A M3-.50 nut is required.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
