Slicer Discord
Arduino car – 3D-Druckmodell von MakerWorld MakerWorld
Engineering

Arduino car

330 Downloads
205 Likes
55 Makes
Zum Modell
This simple Arduino robot car consists of only 14 parts, including 4 wheels. The car is powered by simple and cheap parts.parts list:2X TT-motor4X AA battery1X switch1X servo motor1X l293d Arduino shield1X arduino (clone)1X line follower sensora couple of nuts and bolts the nuts are mostly m3 and a few m4s. For the bolts it is largely the same and of length you better take longer ones. If there is a problem you can always let me know in the comments.
Kategorie
Engineering
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Fortgeschritten Niedrige Konfidenz
Warum?
14-teiliger Zusammenbau · aufwändige Nachbearbeitung
14 Teile zum Zusammenbau Hardware nötig
Supports 1/3
Zusammenbau 3/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

1 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen