Thingiverse
Arduino Mega Case
von ldwfalcon
4
Downloads
3
Likes
0
Makes
This is a case for the Arduino Mega 2560. The holes on the side are a tight fit for M3 screws and the ones on the base are to bolt down the Arduino using M2 screws.
The sides of the pieces might require some sanding(or a lot depending on your printer).
2mmx2mmx~8mm or clear plastic was used to channel the light from the led light to the top of the case.
For the reset button the designated part is simply placed inside the case.
The sides of the pieces might require some sanding(or a lot depending on your printer).
2mmx2mmx~8mm or clear plastic was used to channel the light from the led light to the top of the case.
For the reset button the designated part is simply placed inside the case.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
