Thingiverse
Arduino Obstacle Avoidance Sensor Holder
von KySyth
16
Downloads
20
Likes
0
Makes
Building a Remote Car the Uitrasonic was not up to scratch ,
Adding Avoidance Sensors
Version V001 ,adding more
It not perfect but close
It takes about 11 minutes to print , when it is still soft easy to fits
Adding Avoidance Sensors
Version V001 ,adding more
It not perfect but close
It takes about 11 minutes to print , when it is still soft easy to fits
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
