Arken Throw Lever

This is a remix of the Arken Throw Lever by Danimal_3D which I modified to accept a M3 x H6 heatset insert paired with an M3 x 8mm screw. This allows for an even cleaner install if you have heat set inserts on hand.

Be careful when installing as the sides of the hole warp easily, so I suggest using a lower temperature and maintaining pressure on the flat faces when installing the insert.

According to Arken's website, this should fit all 30/34mm scopes at a much cheaper price point. Fits perfect on my SH4.

Required Hardware:
1 x M3 x H6 heat set threaded insert
1x M3 x 8mm screw