Arkmodel 212a WTC custom Techrack

When i wanted to install a brushless motor, it was overlapping 5mm with the provided techrack. 'adjusting' (iow: cutting extra space) from the rear techrack was not an option because the servo mounts are in the way. So i designed a new techrack that would accommodate my specific electronics for the 212a.

20200829 : adjusted the connector/distributor to include screws (to tighten the small wtc part... (/doh)) parts in blue/grey are to be printed with either PLA,ABS,PETG,... with at least 40% fill and 4 wall thickness. parts in red are to be printed in flexible material like tPU95 also mostly filled to make it watertight. The black part is the rubbery thing that came with the 212a.

20200824 : Added connector/distributor for the boat's functions that are not contained in the WTC (masts,NavLEDs,Bollards,Status LED of the ballast pump, RX antenna). I replaced the 2 connectors Arkmodel included with a 15pins (VGA) connector. In the WTC all dependng wires get soldered to a single row