Thingiverse
Aromamizer Drip tip
door UKDTweak
11
Downloads
11
Likes
2
Makes
These are my attempts at custom wide bore drip tips for the original Aromamizer RTA.
The V2 is tried and tested, ive made one, it did need a tiny amount of filing on the inner diameter to fit, but that is on purpose to make a tight fit.
I will upload a picture of the V2 i made once i have finished painting it.
The V3 is a new creation with dimensions taken via digital calipers, again, it should be a snug fit, but ive not printed one yet, but will update when i have.
Update: V4 added, even though it is saved to size, opening it in 3D Builder and ZYX will often cause it to open in CM instead of MM, beware and check before printing, the external size should be 15.05mm, The file is set upside down for printing and it was printed at 02, Thick Shells and a Brim. No Supports needed. The Blue Drip Tip in my pictures is the V4.
The V2 is tried and tested, ive made one, it did need a tiny amount of filing on the inner diameter to fit, but that is on purpose to make a tight fit.
I will upload a picture of the V2 i made once i have finished painting it.
The V3 is a new creation with dimensions taken via digital calipers, again, it should be a snug fit, but ive not printed one yet, but will update when i have.
Update: V4 added, even though it is saved to size, opening it in 3D Builder and ZYX will often cause it to open in CM instead of MM, beware and check before printing, the external size should be 15.05mm, The file is set upside down for printing and it was printed at 02, Thick Shells and a Brim. No Supports needed. The Blue Drip Tip in my pictures is the V4.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
